Conductive oil pump routine maintenance and repair projects

Conductive oil pump is a high temperature operation, failure will cause personal injury, heat pump daily maintenance is very important, routine maintenance should pay attention to the following: 1, thermal oil pump seal: the front end of the thermal pump set with stuffing box, the sealing performance is more reliable , At the same time in the bearing seat is provided with a mechanical seal, so a large number of leaks will not appear, and a small amount of leakage can be discharged through the leak gate to receive. To check the seal leakage, abnormal, timely maintenance. 2, bearings: heat transfer oil pump transmission medium to the pump cover and bearing the heat from the pump cover and bearing surface cooling, the temperature of the bearing seat to adapt to the shaft sealing performance temperature. Therefore, the choice of pump installation location, to make the pump cover and housing heat for easy proliferation, does not appear any heat storage. Check the bearing temperature, temperature rise, the noise becomes larger, as soon as possible with the change. After each ball bearing has been operated for 3000 hours, it must be dismounted and cleaned with diesel oil to check if the contact surface is damaged. If it is damaged, it must be replaced with a new one. Add grease as required. 3, the pipeline: not allowed to use heat transfer oil pump inlet valve on the control flow, to avoid cavitation. 4, flow: heat pump should not be less than 30% of the design flow of continuous operation and found that the flow of heat transfer oil pump, to find out the reasons for repair as soon as possible. 5, connection: Check the heat transfer oil pump anchor bolts are loose, the pump housing temperature and inlet temperature are the same, the export pressure gauge fluctuations and pump vibration. To establish the daily operation of thermal oil pump routine maintenance and inspection records system to avoid accidents.

Washer Faucet

What kind of valve does a washing machine use? The water inlet valve on your washing machine is the part that connects the two water hoses to the machine, and it controls the flow of both hot and cold water. A problem with the valve can cause the washer to not fill properly or not fill at all.

Tap For Washing Machine, Washing Machine Faucet, Laundry Taps For Washing Machine, Sink Spigot Washing Machine, Washing Machine Water Tap

Kaiping Jianfa Sanitary Ware Co.,Ltd. , https://www.jfsanitary.com