The method and key details for using the array infrared intelligent high-speed dome allow you to operate it quickly and efficiently. Proper installation and maintenance not only ensure smooth performance but also extend its lifespan and reduce the risk of failure.
First, after receiving your smart speed dome, treat it with care throughout the entire process. By handling it properly, you’ll enjoy a lower failure rate and a longer operational life. This is because a well-maintained system performs better and lasts longer.
Second, during installation, many people tend to lift the core manually. However, it's recommended to connect the core to the conductive slip ring interface. This makes lifting the core wire easier and more efficient. If the connection is poor, hold the smart high-speed ball directly to avoid damage.
Third, when wiring, make sure the power cable is close to the dome. Avoid extending the power adapter cable or using a centralized power supply. Centralized power can lead to voltage drops, especially during thunderstorms. Increased resistance may result in insufficient power, potentially damaging the motherboard and making the dome uncontrollable.
Fourth, when connecting wires, clearly distinguish between the RS485 communication line and the power line. Connecting RS485 to the power source can immediately damage the dome. Make proper labels for easy identification and future maintenance.
Fifth, always bring the 220V power line directly to the dome. Do not extend the power adapter cable or use centralized power. Extending the line or using a shared power supply can cause voltage issues, especially on rainy days when resistance increases. This may lead to insufficient power, causing the main control board to discharge and potentially burn out.
Sixth, installing the smart speed dome indoors is different from outdoor installation. When placing it outdoors, strict waterproofing is essential. It’s not advisable to install it outside unless done by professionals. Even if you seal it with glue, small gaps may still exist, allowing water to enter. This can severely impact the dome’s performance and lifespan.
Seventh, testing the dome requires a suitable power source. Using too much voltage can burn the device, while too little may prevent it from reaching its rated power. This can cause continuous discharge of the main control board, leading to component damage and a shortened lifespan.
Eighth, once all the above steps are completed successfully, the installation process is mostly complete. The final step is to recheck everything carefully to ensure that every part was installed correctly. A thorough check helps avoid potential problems down the line.
Shandong Zeen Decoration Material Co., Ltd. , https://www.zeendecor.com