The bathroom is an important functional area in the home life, so you need to spend more time in the decoration. In order to create a comfortable and warm sanitary space, I collected the following decoration points for the owners.
LENS Lens shower room
First, the threshold
The threshold is a barrier that prevents water from overflowing the bathroom. Its design and construction points are:
1) The upper plane of the sill is to be tilted towards the inside of the bathroom so that the water droplets can slide smoothly into the bathroom;
2) The threshold should be the same as the width of the door frame, and the thickness of the door frame should be the same as the thickness of the wall so that there will be no large access when laying the floor tiles, and the chance of creating a breach will be relatively reduced.
Second, the ground waterproof
There are many kinds of waterproof material, and the most popular one is water repellent. When laying a waterproof layer, it should be spread to about 20 cm above the foot of the wall. It must not be lower than the height of the lintel. When there is a reserved pipe on the floor, the waterproof layer needs to wrap the reserved pipe. After the waterproofing of the floor is done and dried, it must be immediately primed with cement mortar or protective measures to prevent damage to the waterproof layer.
Third, the laying of floor tiles
1) There must be about 1 percent of the discharge slope and the slope is towards the floor drain;
2) The seams of the tiles must be the same in thickness, and must be aligned with the seams of the tiles;
3) When the front wall of the bathtub is tiled with tiles, the tiles are best affixed to the bottom of the wall before they are attached to the wall to avoid breakage.
Fourth, washing face
Washing countertops to choose "full body", can not choose to have only one surface plastic shell countertops, because only the surface of the plastic shell of the table once damaged that can not be repaired. In addition, joints must be applied to the joints between the tabletop and the washbasin to prevent the water from oozing from the joints.
Fifth, the toilet
Generally, when installing a toilet, it is customary to use cement mortar to fill the toilet to fix the toilet. In fact, this method is wrong. After this method is used to fix the toilet, the toilet cannot be disassembled again. If the pipeline is seriously blocked, only knock it off. Toilet one way.
Sixth, exhaust fan
When people build houses, they usually pay less attention to bathroom ventilation equipment. Most of them only install an exhaust fan. The bad gas in the bathroom cannot be discharged outside and still just circulates in the bathroom. As an important functional area in the home life, the bathroom will naturally take more thoughts in the decoration.
Experience Floor Tile Decoration Company Toilet Bathroom Interior Decoration Cement Decoration Floor Tile Tile Rubber Floor Tile Decoration Home LD Tile
Tantalum Parts include Tantalum target ,Tantalum crucible and Tantalum Boat .Tantalum parts can be made any size and configuration. Dimensions and tolerances are according to customer's drawings. Price depends on size, complexity, configuration, and additional requirements specified in the order .
Designation
Chief component
Impurities max(%)
Ta
Fe
Si
Ni
W
Mo
Ti
Nb
O
C
H
N
Ta1
Remainder
0.004
0.003
0.002
0.004
0.004
0.002
0.03
0.015
0.004
0.0015
0.002
Ta2
Remainder
0.01
0.01
0.005
0.02
0.02
0.005
0.08
0.02
0.01
0.0015
0.01
Mechanical requirements (annealed condition)
|
Grade(UNS) |
Annealed |
||
|
Tensile strength min, psi (MPa) |
Yield strength min,psi (MPa)(2%) |
Elongation min, % (1 inch gage length) |
|
|
Pure Ta (RO5200, RO5400) |
30000 (207) |
20000 (138) |
20 |
|
Ta-10W (RO5255) |
70000 (482) |
60000 (414) |
15 |
|
Ta-2.5W (RO5252) |
40000 (276) |
30000 (207) |
20 |
|
Ta-40Nb (RO5240) |
35000 (241) |
20000 (138) |
25 |
Tantalum Parts
Tantalum Parts,Puretantalum Crucible,Tantalum Boat,Mo1 Molybdenum Crucible
Baoji Shengyuan Metal Material Co., Ltd. , http://www.baojisymetal.com