Three-dimensional board installation technology 15101180337
Measure the size of the construction area on the wall surface that meets the construction requirements, measure the size of the construction area, and determine the center line so that the installed three-dimensional board is symmetrical on both sides.
2. Draw a line from the center line position, the actual line size is 1mm larger than the size of the installed 3D board.
For example, a three-dimensional board with a specification of 500mm*500mm, the line size should be: 501mm*501mm.
Brushing method:
1. Use a brush to apply glue and apply evenly on the corners of the wall and the 3D board (where the back of the 3D board is raised). When it is not dry, stick the 3D board to the wall frame. 2. Spray the glue with a spray gun (the specific method is roughly the same as above).
When sticking to a 3D board, it is best to stick it up from the middle. Each 3D board should be aligned with the left and lower lines (ie, align the lower left corner, as shown in the "L" position) until the paste is complete.
Each time a 3D board is attached, it needs to be tapped by hand.
When the 3D board is pasted to the position of the border (in the case of the border first), if you can't paste the whole piece, you need to cut it.
Before cutting, measure the effective size of the 3D board that can be attached to the wall frame. Then draw the line on the 3D board and cut it with the big scissors).
After all the three-dimensional plates are installed, the gap between the three-dimensional plates is filled with a caulking agent (powder powder mixed with white latex).
According to the design of the decoration company, make the border of the border (the best inside the border is the light strip).
If the 3D plate is dirty, spray it with detergent or glass water and wipe it off directly.
Aluminum Casting Auto Parts,Aluminum Auto Parts,Aluminum Spare Auto Parts,Heavy Truck Auto Parts
NINGBO AIKEHAN METAL PRODUCT CO.,LTD , http://www.diecastingsupplier.com