There are many customers in the tile press equipment asking the same question. What's wrong with counting? This also depends on the control system of the tile press. The tile counter is not allowed to check whether there is any problem with the counter, and then input the positive and negative values ​​in the computer box to see if the plate is accurate. The production cycle of the tile press equipment is determined by the flow of the tile press machine. The strip steel of the press tile machine is fed from the tail of the machine. The color steel press machine equipment is pressed through various rollers to form the C-shaped steel and sent from the head. After gradually improving the production process, the entire process is finally controlled automatically. There are two types of fixing methods for installing the color steel tile press in the tile press, including the penetration type and the dark buckle concealment type. A. Adjust the compensation amount or adjust the pulse coefficient B. No Show whether the values ​​are consistent or not Allow to add or subtract 5mm a. Use the average speed of the hand to rotate the needle counterwheel for 10 cycles. The displayed value is 10 times the count wheel circumference. Example: 200-cycle display 2000. Allowed to add or subtract 3mm 1. Check whether the counter bracket is loose, whether the pressure is proper, whether the nylon wheel is worn or has glitches 2. Replace b. No adjust the deceleration distance, check the machine chain, no inverter plus Install the inverter
Shaft Assembly,Customized Shaft,Input Shaft,Output Shaft,Counter Shaft
ShaoXing Change Auto Synchronizer Ring Co.,Ltd , https://www.sxcjautoparts.com