Bathroom leakage phenomenon judging bathroom leakage maintenance method

In life, there are always many headaches, such as leaking toilets ! The bathroom is often the place with the most pipes. If there is water leakage, you must check the cause of the leak and decide the method of maintenance. Let's take a look at the introduction of the decoration home decoration network Xiaobian!

å«ç”Ÿé—´æ¼æ°´

First, the judgment of the leaking phenomenon in the bathroom

1. Judgment of pipe seepage

Pipe leakage refers to leakage caused by defects such as damage to the upper and lower pipes, floor drains and toilets. The inspection method is as follows:

(1) Leakage of the upper water pipe

This situation is manifested by the fact that the leakage has continuous, uninterrupted, and sometimes the leakage has an increasing phenomenon, such as closing the main valve of the water pipe, the leakage will immediately decrease.

(2) Leakage of the lower pipe

First observe the amount of leakage, and make a record, then open all the faucets, the toilet flushes several times and pour water to the floor drain. If the leakage increases, it indicates that the pipeline is leaking.

2, surface leakage

There are two ways to identify surface leakage. The specific identification methods are as follows:

(1) Leakage occurs only when bathing, mopping, etc., that is, when water or water is generated on the ground and the wall. In this case, surface leakage can be determined.

(2) Checking and identifying the leakage of the pipeline by inspection. If it is determined that the pipeline is not leaking, it is surface leakage.

å«ç”Ÿé—´æ¼æ°´ç»´ä¿®æ–¹æ³•

Second, the bathroom leak repair method

If the pipe is seeping water, you can only plan the tiles, change the pipes, and re-waterproof. If the surface of the bathroom is seeping water, you can use the following methods for repair:

1. Dispose of dust, oil, water, etc. on the surface and keep the surface dry;

2, in the entire surface that can be drenched into water, such as: tile surface, tile seam, wall seam, tube root and other parts, spray osmotic waterproofing agent, can not leak spray;

3. After the surface of the waterproofing agent is dry, fill all the tile seams, and the damaged and defective parts with waterproofing paste;

4. Reinforce the weak links such as corners, wall edges and tube roots with cloud-plastic steel.

Note: After the waterproof construction is finished, the waterproof material is required to dry (usually after 48 hours) before it can be drenched. Because the bumps in the transportation process continue, the waterproof paste will precipitate, the surface will look a bit dry, it is normal! Before kneading, you should knead for a while, so that the waterproof paste is fully creamed.

The above is the decoration of the decoration home network Xiaobian for the leakage of the bathroom , I hope to bring convenience to everyone's life! For more related knowledge, please continue to pay attention to our decoration encyclopedia section!