First, the storage of wood is not reasonable
1, wrong consequences
When wood is stored, if it is not properly placed, it can easily lead to dry or damp wood. Placing wood in wet or direct sunlight and placing the trim board upright is a common practice for storing timber.
2, the correct approach
In order to prevent the wood from cracking, the wood arrived at the scene should be first wiped with a dry towel to remove dust, and then brushing twice in a row to seal oil; in order to prevent moisture, wood should be placed in a dry and ventilated place; in addition all decorative panels All should be laid flat. A large core plate is placed on the bottom of the decorative panel, and a large core plate is pressed on top so that the plate can remain flat.
Second, ignore the fire protection of wood
1, wrong consequences
In many home renovations, wood products are used in large quantities and their decorative properties are often overlooked. It is important to know that wood has a low ignition point and is flammable, especially dry wood. Dry and dry, if not careful, it is easy to cause fire and endanger the safety of life and property.
2, the correct approach
First, the wood needs to be fireproofed. There are generally two methods for wood fireproofing. One is the impregnation of the fireproofing agent. The second is the surface coating treatment. This treatment can be carried out on the construction site and coated on the surface of the wood. Fire protection agent; Second, wood in the cutting process to pay attention to fire prevention, construction sites need to stay away from the socket and open fire. In addition, sawdust produced by cutting must be cleaned in time because the wood chips are highly flammable.
Third, the woodwork gap is too large
1, wrong consequences
When woodworkers do some activities, they often have large gaps. These are all unqualified, not only affecting their appearance, but also causing problems with splicing.
2, the correct approach
For the wood sealing line, corner line, waist line facing the seam, etc., for the gap have certain requirements, such as the general gap can not exceed 0.2 mm, the angle between the line and the line mouth seam can not exceed 0.3 mm, decorative panels and Board contact can not exceed 0.2 mm, sliding door error does not exceed the entire surface of 0.3 mm, if these values ​​are exceeded, it is best to let the carpenter rework.
Fourth, the mosaic is not detailed
1, wrong consequences
When carpenters do the spelling, in order to speed up the speed and efficiency, and ignore the quality problems, the spellings made are not tight and accurate. In addition, the solid wood door line, the window cover line, the platform line, and the closing The closing of the edges and veneers is also very easy to close the situation, affecting the appearance and performance.
2, the correct approach
Carpenters need to be meticulous in their livelihood, and the parquet must be seamless and maintain a uniform distance. The closes must be tight, firm and flat. The dark sides of the furniture doors and closets inside the doors and doors must be closed with flat wooden lines.
Tips: More practical decoration knowledge, real scene with the shoot, please pay attention to the palm of this site (micro signal: mall_jia).
Woodworking knowledge
Ningxia Xinshuncheng Special Alloy Co., Ltd. , https://www.xinshunchengalloy.com